DESCRIPTION
AND USE
The MULTICOAT SPEED BOND CRACK REPAIR SYSTEM is a unique two
component waterbase polyurethane material. SPEED BOND is used to repair cracks, holes, and
depressions prior to the application of Krete Kote, Slatex or Scratch Kote Systems. SPEED
BOND is also an excellent anchoring material.ADVANTAGES
- Eliminates recurrence of most surface cracks
- Easy to use and install
- Fast set up/Minimum downtime
- Waterbased - environmentally safe to use and apply
SURFACE PREPARATION
All cracks larger than 1/16" in width must be opened with
a crack chaser to a minimum of 1/4" in width. Once opened, all cracks must be cleaned
by sandblasting, waterblasting or water sandblasting.
NOTE: Cleaning out prepared cracks may be done
in conjunction with substrate preparation (See Krete Kote / Slatex Systems).
APPLICATION
Fill properly prepared cracks with SPEED BOND material. Backer
rod or sand should be place in cracks where depths are greater than 3/8". Inject
SPEED BOND material into crack, level with the surface of the substrate. (NOTE: Follow
directions on the cartridge carefully when using material).
After dispensing, immediately spread SPEED
BOND flush with deck surface using a plastic spreader. Allow to harden 10-45 minutes
(depends on ambient temperature) then grind SPEED BOND material to level and abrade
surface.
Now you are ready to coat over the repaired
crack(s) with MULTICOAT Products and Systems. |
CRACKS ROUTED OUT
FILL CRACK WITH SPEED BOND
AFTER SPEED BOND HAS HARDENED, GRIND SURFACE
LEVEL
CRACK IS REPAIRED AND READY TO BE COATED WITH MULTICOAT
PRODUCTS AND SYSTEMS
|
USAGE
ESTIMATE
One Speed Bond cartridge will fill
approximately 20 linear feet of crack 3/8" deep.PACKAGING AND STORAGE
SPEED BOND is furnished in a 12 oz. cartridge.
Store in a dry place at 65-85°F (18° to 30°C).
Note: A special caulking gun needs to be purchased to properly dispense SPEED BOND.
Caulking guns are readily available through Multicoat or your local Multicoat Distributor. |
LIMITATIONS
Do not apply when substrate surface
temperature is below 50°F, above 100°F, if ambient temperature is below 50°F or over
100°F and expected to rise, or if precipitation is expected within a 6 hour period.WARRANTY
Materials are guaranteed with respect to
uniformity and quality within manufacturers’ specifications. Seller makes no other
warranty, expressed or implied, regarding the use of its products. Since use of the
product is beyond the Seller’s control, the Buyer assumes all risks of use.
Seller’s sole obligation shall be to replace material if found to be defective.
Seller shall not be liable for any damages, injury, loss, direct or indirect or
consequential, resulting from use of its products. |