KRETE KOTE SYSTEM

I. DESCRIPTION and SCOPE

The MULTICOAT KRETE KOTE System is a super bonding, flexible Synthetic Resin modified cementitious coating which forms a cost-effective, durable, anti-skid, weather and chemical resistant protective coating over properly prepared substrates. It can be applied to driveways, walkways, steps, decks, buildings, bridges, etc.

The scope of the specification is to describe all materials and procedures required for installation of the KRETE KOTE SYSTEM.

1. KRETE KOTE 2000 Protective Coating

As manufactured by MULTICOAT CORPORATION

Shall be a synthetic resin modified cementitious material, furnished in dry form, mixed with potable water at job site in proportions so as to provide alternate consistencies for application by brush, squeegee, spray or trowel.

Physical properties of the cured mix shall meet or exceed the following test criteria:

2. ACRATHANE COLORSEAL/CLEARSEAL

As manufactured by MULTICOAT CORPORATION

Shall be a high solids waterbased Synthetic Latex protective coating for cleaning ease. Proprietary formulation and physical characteristics designed for compatibility with KRETE KOTE 2000.

III. SURFACE PREPARATION

1. Substrate must be structurally sound, free from grease, oil, paint, dirt, dust, sealers, laitence, curing compounds and other foreign materials which may prevent proper bonding. Use shot blast, sand blast, or water blasting with sand injector (3500 psi minimum). For heavy grease use biodegradable degreaser, with steam cleaning machine, if necessary.

2. Cracks must be repaired and all holes, voids, behives, etc. must be filled with MULTICOAT SPEED MIX.

3. Expansion joints should be installed, cleaned if existing.

4. Surface should be dry to touch prior to APPLICATION.

1. FIRST COAT KRETE KOTE 2000

A. Mix with potable (clean) water in approximate amount of 1 ¼ -1 ½ gallons per 65 lb. bag preferably with MULTICOAT Mixing Paddle. Mix vigorously to disperse all lumps and thoroughly wet all particles.

(1-1 ½ minutes minimum after all dry material added)

B. Adjust to desired consistency by addition of small amount of water, if needed.

C. Apply with roller, trowel, or squeegee. Allow to set, usually 1-2 hours, longer in cool weather. Substrate condition may require a second coat - Same as First Coat.

2. TEXTURE COAT

A. Same as First Coat except apply with Hopper Gun - trowel "knock down" for French Lace Texture.

B. Allow to cure minimum of 12 hours for foot traffic, 48-72 hours for vehicle traffic, longer in cool weather.

3. COLORSEAL / CLEARSEAL - Apply per instructions in two thin coats.

Do not apply when substrate surface temperature is below 50oF, above 100oF, if ambient temperature is below 50oF and falling, over 100oF and expected to rise, or if precipitation is expected within a 24 hour period.

VI. WARRANTY

Materials are guaranteed with respect to uniformity and quality within manufacturers’ specifications. Seller makes no other warranty, expressed or implied, regarding the use of its products. Since use of the product is beyond the Seller’s control, the Buyer assumes all risks of use. Seller’s sole obligation shall be to replace material if found to be defective. Seller shall not be liable for any damages, injury, loss, direct or indirect or consequential, resulting from use of its products.