Multicoat PONDS & WATER FEATURES (AG) System offers a completely waterproof solution to projects that are subject to high movement, water loss, and/or are located above the soil level. This membrane driven solution provides a long-lasting barrier from all elements and risks from harming your project. This system should be chosen cautiously over our universal SHIELD KOTE system in areas that are on grade or below grade to prevent issues stemming from negative side hydrostatic pressure.
Apply Vapor Shield with a pump sprayer in conjunction with water, back to back. Repeat for a total of 2 coats. Allow 24 hours to dry.
Apply Scratch Kote 2000 with a hopper gun, pressure sprayer or a ¾”-1¼” nap roller. Applied material should peak, not slump.
Stir with hand paddle. Roll, brush or spray Mulasticoat over the area to be waterproofed in two (2) coats. Embed Polyester Stitch Bond Fabric immediately during the application of the first coat over all flashing, plane changes, and joints and apply additional material on top of it. Allow to dry thoroughly between coats.
Using a trowel, hopper gun, or magic trowel, apply Pond Coat to the surface at the desired thickness as long as it is under 1/4″. In some cases, shrinkage cracks may appear, simply apply extra material to those areas upon completion.
ASTM D2370 PSI 203
ASTM 2370 1148%
ASTM C297 162 Cohesive
ASTM C 1306 Pass>45PSI
12” Water/Film@40mil Pass 96hrs/No Effect
Mandrel Bend ASTM D522 ½“ Room Temp Pass
1” @ -5°F Pass
½“ @ -5°F Pass
175
Compressive Strength (28 day)
3125 psi
1375 psi
2250%
Passed*
*Toxicity testing was done on flat head minnows and rainbow trout, with no adverse affects to either species of fish
ASTM-G 23 2000 hrs – Passed
ASTM-C 109 45 days air cured – 2595psi
ASTM-C 190 457 psi
ASTM-C 297 225 psi
ASTM-1242A 1000cyc-1000gms Passed
ASTM-C 67 Passed
ASTM-D 790 Modulus of Rupture – 770psi
MIL-D3134F Passed
For Safety Data Sheets, visit our “Resources” page
A: Yes. Allow material to dry 7 to 10 days prior to filling with water. After filling, run circulation pumps/filters followed by a light brushing to remove any surface containments prior to adding fish. Longer dry time will be required for interior applications.
A: Yes as long as you mix the colorant with the water prior to adding the dry mix to it. You should not mix the colorant in after it has been mixed with water.
A: Yes, we recommend approximately 92-100% removal of all old coatings prior to the application of this system.
A: No. MULASTICOAT creates a uniform membrane and is not designed to be a “universal” material that can bond with any coating.
